2014.12.13 11:44

// BDADDR: Bluetooth device address

// CRYSTAL_FTRIM: Crystal frequency trim

// RADIO_RX_ADC_CONFIG: Radio receiver's RX ADC config

// USER_KEYS: User keys

// UART_RATE: UART connection speed

// UART_CONFIG: UART configuration

// TX_POWER_LEVEL: Transmit power level

// ERR_REPORT_FAULT: Report faults to host

// ERR_PANIC: Cause faults to panic

// WD_TIMEOUT: Watchdog timeout

// WD_PERIOD: Watchdog period

// SLEEP_MODE: Sleep mode

// SLEEP_CLOCK_ACCURACY: Sleep clock accuracy allowance

// DEBUG_SLEEP_CLOCK: Sleep clock debug signal

// DEBUG_RADIO_RX: Radio RX event debug signal

// DEBUG_RADIO_TX: Radio TX event debug signal

// IDENTITY_ROOT: Identity Root

// ENCRYPTION_ROOT: Encryption Root

// XTAL32K_LEVEL: 32kHz crystal drive level

// XTAL16M_LEVEL: 16MHz crystal drive level

// XTAL16M_WAKEUP: 16MHz crystal wakeup parameters

// BATTERY_THRESHOLD: Battery "low" threshold voltage

// NVM_START_ADDRESS: NVM Start Address

// NVM_SIZE: NVM Size

// SPI_FLASH_BLOCK_SIZE: SPI Flash Block Size

// NVM_NUM_SPI_BLOCKS: NVM SPI Flash Number of Blocks

// I2C_EEPROM_INIT_TIME: I2C EEPROM Initialisation Time

// SPI_FLASH_INIT_TIME: SPI Flash Initialisation Time

// TEMPERATURE_ADJUST: Thermometer offset adjustment

// RADIO_DATA_WIN_MIN: Radio Data Window (Minimum)

// RADIO_DATA_WIN_MAX: Radio Data Window (Maximum)/

// RADIO_SLEEP_WIN_MIN: Radio Sleep Window (Minimum)

// RADIO_SLEEP_WIN_MAX: Radio Sleep Window (Maximum)/

// I2C_DISABLED_PULL_MODE: I2C Pull resistors config

'초보의 아웅다웅 설계하기 > CSR1010' 카테고리의 다른 글

CSR *.keyr Set  (0) 2014.12.13
Posted by 초보 HW 엔지니어 로망와니

댓글을 달아 주세요